Professional literature and technical standards according to the topic of the thesis.
Guidelines for the Preparation and Submission of Final Theses [online]. Ostrava: VŠB-TU, FS. 2005. Last updates 2.10.2017. Available from: https://dokumenty.vsb.cz/docs/files/en/bd31e883-47e7-463c-aabf-ebad9b8a0560.
VSB – Technical University of Ostrava. Rules and Recommendations for the Use of Artificial Intelligence at VSB – Technical University of Ostrava [online]. Ostrava: VŠB-TUO, 2024. [cit. 2025-02-03]. Available from: https://dokumenty.vsb.cz/docs/files/en/befa2368-07a4-49c3-8582-d5934a32e3d8
VŠB – Technical University of Ostrava. Intellectual Property Protection at VSB-TUO [online]. Ostrava: VŠB-TUO, 2024. [cit. 2025-02-03]. Available from: https://www.vsb.cz/ctt/en/services/for-employees/intellectual-property-protection/
Diplomový projekt 1
| Type of study | Follow-up Master |
|---|---|
| Language of instruction | English |
| Code | 361-5401/02 |
| Abbreviation | DP1 |
| Course title | Diplomový projekt 1 |
| Credits | 13 |
| Coordinating department | Department of Power Engineering |
| Course coordinator | Ing. Michal Stáňa, Ph.D. |
Subject syllabus
The syllabus is not structured by teaching weeks; instead, it outlines the sequential general steps required to fulfill the course completion requirements. This format is used because the individual steps may vary in time intensity.
1. Introduction to the assignment and consultation with the instructor.
2. Acquisition of supporting documentation and data for development.
3. Establishment of basic mass and energy balances and the equipment flow sheet.
4. Balance calculations and mass calculations for the equipment.
5. Preliminary design and selection of equipment dimensions.
6. Development of technical drawings and design documentation.
7. Refinement of technical drawings and design documentation.
8. Preparation of the final version of the thesis/project. Presentation of results to peers via a lecture, utilizing computing and audiovisual equipment.
1. Introduction to the assignment and consultation with the instructor.
2. Acquisition of supporting documentation and data for development.
3. Establishment of basic mass and energy balances and the equipment flow sheet.
4. Balance calculations and mass calculations for the equipment.
5. Preliminary design and selection of equipment dimensions.
6. Development of technical drawings and design documentation.
7. Refinement of technical drawings and design documentation.
8. Preparation of the final version of the thesis/project. Presentation of results to peers via a lecture, utilizing computing and audiovisual equipment.
Literature
Advised literature
Professional literature and technical standards according to the topic of the thesis.